Decavator is an adhesive mediator who improves the liability of the various DEKALIN products based on MS Polymer, such as decasyl, on closed surfaces. In the event of substrates with a low surface voltage (mostly for plastics) or if the composition of the underground should not be known, it is advisable to use the Dekavator Habt activator. It ensures permanent gluing and prevents moisture from entering outdoors. The decavator improves the adhesiveness, because it acts as a chemical bridge between the jack and the adhesive.
Applications
For the pretreatment of:
- Aluminum, steel, copper and brass
- Powder -coated metal
- Lacquered metal (the compatibility of the solvent with the surface should be checked beforehand)
- (Ceramically coated) glass
- Polyester (GfK)
- ABS and PVC
Characteristics
- Adhesive and cleaning
- Quickly drying, ventilation time approx. 5 minutes
- Easy to use
- Economical consumption
processing
The substrates should be clean, dry, dust and fat-free. The packaging should remain well closed until use. Dekavator can be used directly from the original packaging, provided the pollution and the increase in viscosity is prevented. The color should be transparent (if the color is milky, the product is no longer to be used). It is to be prevented from getting in touch with water until the product has hardened. Therefore, it is recommended to make two openings at the top of the can in the aluminum seal (if possible, depending on the can). Close the can again immediately after use. Apply the decavator in a thin layer. Grate the surface vigorously with a clean, color -free cloth, moistened with a decavator. After a drying time of about 5 minutes (the solvents should be completely ventilated; the lower the temperature, the longer the drying time), the adhesive/sealant can be applied. The best liability is achieved if the adhesive/sealant is applied within 4 hours after the drying of decavator. Therefore, only as much should be pretended as can be sealed/glued within 4 hours. Avoid touching the pretreated surfaces because the fat film of the fingers can lead to poor liability.
Note 1:Due to the intolerance to paint colors, the decipator should not be applied to areas that are to be painted afterwards. In this case, a template or masking tape should be used to apply decavator only in the area of gluing/sealing (however, it is possible to remove remnants of decavator with e.g. removing isopropyl alcohol (IPA) or acetone).
Comment 2:In the case of heavily soiled surface, e.g. IPA or acetone must be cleaned beforehand. It is recommended to test the compatibility of the surface with this cleaner in advance.
Delivery time: 1-3 working days
Technical specifications:
- Set component: approx. 8%
- Specific density (20 ° C): approx. 0.76 kg/liter)
- Flame point: approx. 9 ° C
- Drying time (20 ° C/50% R.H.): approx. 5 minutes
- Color: transparent
- Packaging size: 30ml aluminum can
- Consumption: approx. 20m² / liter
- Storage temperature: +5 ° C - +30 ° C
- Storage: unopened up to 12 months
Scope of delivery:
1x Dekalin Dekavator 30ml
