The Victron Battery Protect BP-100 (MPN BPR000100400) separates the battery from the less important consumers before it is fully unloaded (which would be damaged) or before it no longer has enough energy to start the engine, etc. In addition, the BP series via an overvoltage protection that switches off the load at 16V or 32V battery voltage and preserves from damage. The BP supports AGM, lead acid, gel and lithium batteries.
6 different switch -offs adjustable
The battery protect is very flexible can be set to different switch-off voltages. The following switch -off thresholds can be activated on the device: 10.5V / 21V, 10V / 20V, 9.5V / 19V, 11.25V / 22.5V, 11.5V / 23V, 11.8V 23.6V
There are different counter -stone shells for most switch -offs that can be chosen. This device is the perfect protective device for your battery and thus ensures a maximum lifetime, because most voltage converters or charge controllers have an undervoltage protection, but this only applies at quite low values that are usually in the range of 10.5V / 21V . The higher this switch -off threshold, the longer you will enjoy your batteries, which are usually pretty cost -intensive.
Significant product properties summarized
- For 12V and 24V batteries with automatic detection of the voltage area, the battery range
- 6 different switch -off voltages selectable
- 100a maximum permanent current
- Easy programming and status display of the settings via Siebensegentment display
- Extra mode for lithium batteries - In this mode, the BP can be controlled by the VE.Bus BMS
- very low power consumption
- Explosion protection with integrated MOSFET switch replace the relays and thus reduce the risk of sparking to zero
- Integrated alarm output
Exit for delayed alarm
The alarm output is activated when the battery voltage falls for more than 12 seconds below the preset value for switching off. Switching on the engine therefore does not activate the alarm. The alarm output is a short-circuit-protected open collector output, which is connected to the negative (minus) rail. Max. Strom 50 mA. The alarm output is usually used to activate an acoustic signal, LED or a relay.
Load shutdown and reelnation delay
The load is switched off 90 seconds after activating the alarm. If the battery voltage rises again within this period (after the engine has started, for example) to the threshold value for connecting, the load is not switched off.
Delivery time: 1-3 working days
Scope of delivery:
1x VICTRON BPR000100400 BP-100 battery protection 100a 12V 24V
1x operating instructions
