The Victron Energy 12/1600 230V VE.Direct IEC inverter (MPN: PIN122161100) is a pure sine wave inverter designed to power compatible 230 V loads from a 12 V battery system. It delivers 1,450 W of continuous power at 25 °C, provides 1,600 W for up to one hour, and 2,100 W for 15 seconds, and combines the IEC-320 output with VE.Direct communication, ECO mode, and a remote control connection.
Key Benefits
1,450 W continuous power at 25 °C and 1,300 W at 40 °C
1,600 W limited-time power for up to one hour
2,100 W peak power for up to 15 seconds
Pure 230 V sine wave output via IEC-320
VE.Direct for configuration and monitoring
ECO mode with 1 W idle power consumption
Configurable undervoltage, restart, and alarm thresholds
Dynamic, load-dependent undervoltage shutdown
Remote on/off connection for external control options
Three clearly defined power levels
At an ambient temperature of 25 °C, the inverter can supply loads with a continuous power output of up to 1,450 W. At 40 °C, the continuous power output is reduced to 1,300 W. Additionally, 1,600 W is available for up to one hour and 2,100 W for up to 15 seconds. This allows for loads whose power consumption exceeds their normal rated power when switching on or during certain operating phases. Before connection, the continuous power, peak power, and duration of the inrush current must be checked separately. The model designation 12/1600 does not mean that 1,600 W is continuously available under all operating conditions.
VE.Direct and VictronConnect
VE.Direct allows you to monitor battery and output voltage, load, operating status, as well as warnings and alarms. With VictronConnect, you can also adjust the output voltage and frequency, ECO settings, and the thresholds for undervoltage shutdown, restart, and charge detection. A separately available VE.Direct-to-USB interface is required to connect to a computer. Smartphones and tablets can be connected via the optional VE.Direct Bluetooth Smart dongle. Bluetooth and Wi-Fi are not integrated into the inverter. The remote on/off connection allows control via an external switch, a suitable control panel, or a compatible battery management system.
ECO Mode and Battery Protection
In normal idle mode, power consumption is 14 W. ECO Mode reduces this to 1 W by switching the inverter to standby mode under low load and checking for an active load at set intervals. The load threshold and check interval are configurable. Adjustments may be necessary for small loads or loads that are active only briefly. Adjustable thresholds for shutdown, restart, alarm, and charge detection are available to protect the battery. Additionally, dynamic shutdown can be activated, which adjusts the undervoltage threshold to the battery’s current load.
Properly Size the 12-V Connection
The inverter is connected to the battery bank via screw terminals and accommodates battery cables with a maximum cross-sectional area of 50 mm². This value describes the connection capacity of the terminals and is not a general cable sizing specification. The required conductor cross-section, cable length, external fuse, and battery disconnect device must be designed to suit the system. The IEC-320 outlet is not a GFCI outlet and must not be connected to a household electrical system, generator, or any other AC power source. The inverter contains neither a charger nor a solar charge controller nor an automatic transfer switch. Installation, configuration, grounding, and the protection concept must be performed by a qualified electrician. The device requires a dry, well-ventilated environment and approximately 10 cm of free space for air circulation.
Protects against
Short circuit
Overload
Overtemperature
Critical battery voltages
Technical Specifications
Nominal DC voltage: 12 V
DC input voltage range: 9.2 to 17 V
Continuous power at 25 °C: 1,450 W
Continuous power at 40 °C: 1,300 W
Short-term power: 1,600 W for one hour
Peak power: 2,100 W for 15 seconds
Output voltage: 230 V AC ±3%
Output frequency: 50 or 60 Hz ±0.1%, configurable
Maximum efficiency: 91%
Idle power consumption: 14 W
Idle power consumption in ECO mode: 1 W
Maximum battery cable cross-section: 50 mm²
Protection rating: IP21 for base mounting
Cooling: Forced air cooling
Operating temperature range: -40 to +65 °C
Permissible humidity: maximum 95%, non-condensing
Weight: 8.9 kg
Dimensions: 117 × 231 × 395 mm
Package contents:
1x Victron Energy Inverter 12/1600 230V VE.Direct IEC
1x IEC-320 plug
